Package Content: 10m kit： 12x adjustable nozzle 12x insert 12x positive three links 4/7 capillary 10M 1x watering timer 1x solar panel 1x usb cable 1x filter 5m kit： 1x watering timer 1x solar panel 1x usb cable Product Specifications: 1. Battery: 3.7V/2000mAH. 2. Charge voltage: 4.2V-6V 3. Water pump flow: 900mL/ minutes (typical value). Install The first： installation diagram is shown in the figure. 1. Need tools: scissors or art knives. 2. Inlet installation: A. fixed the main body and water source, measured the length of the water pipe required, and intercepted a proper length of water pipe with a scissors. One head was inserted into the inlet of the water inlet; the outer head was inserted in the blue circle of the filter, inserted into the bottom, and then put into the water source. B. if the water is pure water or tap water, the filter can be placed at the bottom of the water source; if it is a no clean water source such as rain water, the filter needs to be fixed to the bottom of the 5-10 CM to prevent the silt from entering the filter. 3. Drop heads installation: A. if only one drop head is connected, the water pipe of the corresponding length is taken, one head is connected to the outlet, one head is connected with the drop head, then the ground is inserted into the flowerpot and the drop head is inserted into the ground. B. installation of a number of dripper can be cut at the fork, access to tee pipe connector, use one of the ports to connect the pipe dripper, the other head pipe through the next layer tee pipe connector or drop head. The rotary nut part can adjust the volume of water, tighten and reduce the water yield, otherwise increase. Operation Instructions 1. Cycle time: From the start of pump opening, calculate the interval between the next pump. DAY means the number of days, and H is an hour. The number of days plus hours represents the cycle time. 2. Watering time: The opening time of each circulating pump is in seconds. 3. Working state: Raindrop shows that the pump is working. When the watering time is displayed Lo, it means that the battery is not fully supplied and needs to be charged. Electric source Setting Increase Start / Reset 1. Electric source: open or close the power for 3 seconds. When the pump is turned on, the pump starts to work and starts the timer again. 2. settings: press the set key of the first number flicker, at this time press the increase key corresponding number will change from the 0-9 cycle; select the required number again press the setting key, the number jump to the next, use the same method to set, after completion press the start / reset key to complete setting and start the pump. 3. Start/Reset: When the pump is working, press this button to stop working; when the pump is not working, start the pump and restart the calculation of cycle time. Matters needing attention 1.When using the watering device for the first time, please use the USB charging cable to charge the watering device for 8 hours to ensure that the watering device battery is fully charged（Device cannot start if battery is low ）. The subsequent use of the watering device can continuously supply power to the watering device battery using solar panels. 2.If the solar watering device is not used for a long time, fully charge and discharge the solar watering device once every 3 months and recharge it to 70% power to prevent battery damage. 3.please do not spray or soak. 4.The main body should be placed above the water level. 5.The head must be kept clean. 6.The main body inlet must be blocked when not in use to prevent dust from entering the pump and causing damage. 7.When the water source is higher than the dripper, it will cause the siphon phenomenon of dripping water. You can adjust the water source or the dripper position, or let one of the drip heads be higher than the water source.